Biomass Burner Veneer Dryer
High quality biomass burner veneer dryer, a patented veneer dryer independently developed by Shine Machinery, can directly use crushed wood waste, tree bark as fuel to provide hot air to the veneer dryer, which greatly reduces the drying cost and is energy-saving and environmentally friendly at the same time. No need to buy a steam boiler or thermal oil heater. The temperature in the burner is 40-60℃ higher than that of the traditional dryer (steam, thermal oil), and the temperature is controlled at 140-200 ℃, which shortens the drying time and increases the output.
Biomass Burner Veneer Dryer
Biomass burner veneer dryer adopts frequency conversion to adjust feed speed according to your veneer thickness and moisture content to achieve an ideal drying effect. The veneer after drying by the Shine veneer dryer is smooth and the moisture content is uniform, the high-temperature drum has direct contact with the wet veneer for heat transfer, the heat efficiency is high, the heat loss is small, and the heat loss is reduced.
The biomass burner is one of the Shine patented products, can burn all kinds of waste wood directly to reduce the drying cost mostly. The temperature in the biomass burner is up to 800 degree Celsius and 140-180 degree Celsius in the heating section of the dryer, which it can be adjustable and the temperature control accuracy ±5℃. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent. It is also environmental-friendly with no smoke and no dust, low energy consumption with high output and quality.
Product Parameter of Biomass Burner Veneer Dryer
Model No | GTH30-28 |
Working Width | 3m |
Deck | 2 |
Roller material | Q235B, φ89 steel pipe |
Heating area length | 24m |
Cooling area length | 4m |
Veneer thickness | 0.6-8mm |
Veneer water moisture | Fresh veneer to about 10% |
Heating material & drying temperature | Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent. |
Drying capacity (m³/24h) | 35-40cbm |
Veneer transport speed | 5-22m/min，16A chain |
Hot air blower | Power:5.5KW（6pc） |
Traction motor | Power: 5.5KW，frequency control（2pc） |
Cold air blower | Power: 5.5KW（1pc） |
Air intake fan | Power : 7.5KW（1pc） |
4 ton biomass burner | Power: 16.5KW |
Total power | 73.5KW |
Actual electricity consumption | About 52kwh per hour |
Covered Space of the whole machine | 34M X 9M X 3M |
Customer Case
Certification
Factory
Our Services
Pre-sale services:
1) Provide the free consultation of all veneer production line
2) According to the clients' special requirement, offering the reasonable plan and free design to help to select the equipment.
3) Welcome to visit our factory.
Services during the sales:
1) Inspect the machine before leaving the factory.
2) Oversea install and debug the equipment.
3) Train the first-line operator.
After sale services:
1) 24 hours online service.
2) Provide the VIDEO with Install and debug the equipment.
3) Provide technical exchanging（Technical phone：+8615806625431）Door to door service is possible.
