Veneer Jet Dryer Machine

Type: Biomass Veneer Dryer

Working Width: 3m

Veneer thickness: 0.8-8mm

Heating Area Length: 24m

Drying capacity (m³/day) : 80-90

Veneer Water Moisture: Fresh veneer to about 0-15%

Cost: 6-12$/m3 (Labor+Fuel+Electricity)

Heat Source: Biomass Burner (Other options available)


  Связаться сейчас
информация о продукте

Veneer Jet Dryer Machine


Veneer jet dryer machine has the advantages of simple operation,safety and practicality, stable operation and easy maintenance ,hot pressing-leveling-drying are finished at the same time &and others.The roller dryer  machine is mainly used in plywood industry, and used to remove moisture from the veneer.The dryer machine can effectively use various resources and occupy a small area.The roller dryer machine can be divided into two parts: heating section and cooling section.The heat medium can be oil and heat steam. 


Veneer Jet Dryer Machine


working principle:

working principle is veneer veneer drying technology in steel tube under the clamping roller, two by preheating the oven temperature to 140, and then enter the upper and lower roller and through the hot air pipe to the single board upside down between hot high pressure blowing for quick dry, so you can make the veneer smooth moisture content after drying of uniform, And it has the characteristics of high temperature roller and wet veneer direct contact heat transfer, high thermal efficiency and small thermal loss.


Veneer Jet Dryer Machine


Product Parameters of Veneer Jet Dryer Machine


Model No

GTH30-28

Working Width

3.0m

Deck

4

Roller material

Q235B, φ102 special shaft tube

Heating area length

24m

Cooling area length

4m

Veneer thickness and size

0.8-8mm

Veneer water moisture

Fresh veneer to about 8-10%

Heating material & drying temperature

Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent.

Drying capacity (m³/day)

80-85

Veneer transport speed

5-22m/min,16A chain

Hot air blower

Power: 4KW(24pc)

Traction motor

Power: 5.5KW,frequency control(4pc)

Cold air blower

Power: 4KW(8pc)

Air intake fan

Power: 11KW(1pc)

10 ton biomass burner

Power: 16.5KW

Total power

161.5KW

Actual electricity consumption

About 114kwh per hour

Overall Dimension(L*W*H) 

43m×12m×3.5m


Veneer Jet Dryer Machine


Customer Case


Customer Case


The installation


The installation


The Factory


The Factory


Packaging & Shipping


Packaging & Shipping

Отправьте нам свое сообщение
x