What are the factors that cause the veneer dryer to fail to reach its output?

Are you worried that the veneer dryer you bought will not reach its output? Or have you already purchased it but the expected output has not been achieved? The main reasons are as follows:

First: the type of wood that needs to be dried. Some special woods take longer to dry.

Second: the initial and final moisture content of the dried veneer. If the original moisture content is high or contains a lot of impurities, it will increase the drying time and energy consumption, thereby reducing production capacity.

Third: whether the heat source of the dryer can reach the required heat. If the heat provided by the heat source does not meet the needs of the dryer, the output will be relatively low.

The temperature in the oven of the shine veneer roller dryer is controlled at 140-180℃, which shortens the total drying time of the veneer, thereby greatly increasing the drying output. The heat exchanger adopts step-by-step heat exchange. The specifications of the heat exchanger in each section are different, and the hot air in the heat exchanger can be evenly distributed to the veneer. The moisture content of the veneer after drying is uniform and flat, without wrinkles or end corrugations, cracks, and the surface gluing state is good, which fully improves the energy utilization rate and saves unnecessary energy waste.